Intel R1304BTLSFAN, Руководство по обслуживанию

Страница: 48 / 112

28 Intel
®
Server System R1304BTSSFAN/R1304BTLSFAN/R1304BTLSHBN Service Guide
Removing and Installing the Server Cover
Removing the Server System Cover
You must operate the server system with the server system cover in place to ensure proper
cooling. You must remove the cover to add or replace components inside of the server.
None of the internal components are hot-swappable. Before removing the server system
cover, power down the server and unplug all peripheral devices and the AC power cable.
Note: You may need a non-skid surface or a stop behind the server system to prevent the server
system from sliding on your work surface.
AF003681
C
A
B
B
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” on page iii .
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the AC power cord.
4. Remove the screw at the front of the chassis. See letter “A” in Figure 12.
5. Push down the two buttons, then push rearward. See letter "B" in Figure 15. Slide
the cover back until it stops and then lift the cover upward to remove it. See letter
“C” in Figure 12.
Figure 12. Removing the Server System Cover