4
General Installation Process
7
Install Memory Modules
DDR3 DIMM Memory Ide
ntification:
Other
Memory
DDR3
CAUTION:
Observe normal ESD (ElectroStatic
Discharge) procedures to avoid possible damage to
system components.
DIMM notch and socket bump must align as shown below.
C
AIRFLOW
Chassis Front
2
3
1
4
A
B
TIM
D
CAUTION:
Do not
over-tighten
fasteners.
E
Note:
Heatsink styles may vary.
Remove the protective film on the TIM if present.
D
CAUTION: The heatsink has thermal interface
material (TIM) on the underside of it. Use caution so
that you do not damage the thermal interface material.
Use gloves to avoid sharp edges.
E
C
A
B
Align heatsink fins to the front and back of
the chassis for correct airflow.
Airflow goes from front-to-back of chassis.
Each heatsink has four captive fasteners and
should be tightened in a diagonal manner using
the following procedure:
Using a #2 Phillips* screwdriver,
start with screw 1 and engage screw
threads by giving it two rotations
and stop. (Do not fully tighten.)
Proceed to screw 2 and engage screw
threads by giving it two rotations and
stop. Similarly, engage screws 3 and 4.
Repeat steps C and D by giving each
screw two rotations each time until
each screw is lightly tightened up to
a maximum of 8 inch-lbs torque.
6
Install Processor Heatsink
Install Memory Modules ...continued
Memory Configurations and Population Order:
Intel
®
Server Board
S1400SP
DI
M
M
_C
2
DI
M
M
_C
1
DI
M
M
_B
2
DI
M
M
_B
1
DI
M
M
_A
2
DI
M
M
_A
1
CPU Socket
Note:
For additional memory configurations, see the
Service Guide
on the Intel
®
Server Deployment & Management DVD that accompanied
your Intel
®
Server System, or go to:
http://www.intel.com/p/en_US/support/
(post-production)
Memory sizing and configuration is supported only for qualified DIMMs approved by Intel
®
. For a list of supported memory, go to:
http://serverconfigurator.intel.com/sct_app.aspx
(post-production)
For the best performance, a minimum of three DIMMs per CPU is recommended, populated in the blue slot of each memory channel.
Содержание R1000SP
Страница 2: ...This page is intentionally left blank...
Страница 20: ...G64256 003...