Intel PXA27 Series, Быстрый старт

Страница: 14 / 16

14 Intel
®
PXA27x Processor Developer’s Kit - Quick Start Guide
3.3 PMIC Card Switch Settings
For the PMIC card, SW4 is comprised of 5 subswitches. The defaults for these switches are as
follows:
On the PMIC card revision 1.2, the following headers have 0.1 Ohm resistor, in parallel to every 2-
pin header: J9, J10, J11. Header J8 has no parallel resistors.
ALL 100Mil headers, except for J11(16-15, 14-13, 12-11, 9-10), must have 2-pin jumpers installed
between corresponding pins as illustrated below:
Figure 4. PMIC Power Measurement Headers (Factory Default Settings)
3.4 Repeating Troubleshooting Procedures
If the POST software does not start or cannot complete without errors, repeat the procedures in
Section 3.2 several times.
If the POST software indicates that problems persist, return the kit to Intel Corporation (see
Section 1.5 ).
Subswitch Default
1 On
2 On
3 On
4 On
5 On