User Guide for NUC7i3DNHE, NUC7i5DNHE, and NUC7i7DNHE
4
Installing and Removing Memory
Intel NUC Kits NUC7i3DNHE, NUC7i5DNHE, and NUC7i7DNHE have two 260-pin DDR4 SO-DIMM
sockets. Memory requirements:
•
1.2V low voltage memory
•
1866 or 2133 MHz SO-DIMMs
•
Non-ECC
Find compatible memory modules in the
Intel
®
Product Compatibility Tool
:
•
•
•
Install SO-DIMMs
If you plan to install just one SO-DIMM, install it in the lower memory socket.
To install the SO-DIMMs, follow these steps:
1.
Observe the precautions in "Before You Begin" on page 2.
2.
Turn off all peripheral devices connected to the computer. Turn off the computer and
disconnect the AC power cord.
3.
Align the small notch at the bottom edge of the SO-DIMM with the key in the socket.
4.
Insert the bottom edge of the SO-DIMM into the socket.
5.
When the SO-DIMM is inserted, push down on the outer edge of the SO-DIMM until the
retaining clips snap into place. Make sure the clips are firmly in place.
Removing SO-DIMMs
To remove a SO-DIMM, follow these steps:
1.
Observe the precautions in "Before You Begin" on page 2.
2.
Turn off all peripheral devices connected to the computer. Turn off the computer.
3.
Remove the AC power cord from the computer.
4.
Remove the
computer’s cover.
5.
Gently spread the retaining clips at each end of the SO-DIMM socket. The SO-DIMM pops out of
