Intel M20NTP1UR, Руководство по системной интеграции и обслуживанию

Страница: 75 / 114

Intel® Server System M20NTP1UR - System Integration and Service Guide
75
6.12 System Battery Replacement
Required Tools and Supplies
•
Compatible CR2032 lithium battery
• Anti-static wrist strap and conductive workbench pad (recommended)
1. Power off the system and disconnect all cable from the back of the system.
2. Remove the system top cover (see Section 6.1.1 ).
3. Remove the Air Duct (see Section 6.2.1 )
4. Remove riser card assembly (see Figure 76 ).
5. Remove the battery from the server board (See Figure 94 )
Figure 94. System Battery Removal
•
Gently press the metal latch to release the battery (see Letter “A”).
• Remove the battery from the socket (see Letter “B”).
•
Dispose of the battery according to local laws.
6. Locate and unpack the replacement battery
7. Orient the battery with the flat positive ‘+’ side facing up.
8. Install the battery into the battery connector socket on the server board (see Figure 95 )
Figure 95. System Battery Installation
• Place the leading edge of the battery beneath the metal latch within the battery socket
•
Lower the back edge of the battery into the socket until it is securely seated
9. Re-assemble the system
10. Power on the system and access the <F2> BIOS Setup Utility to restore BIOS Settings and reset the
system time and date