28
PCH-FW Configuration
Press [Enter] to configure Management Engine Technology Parameters and make
settings in the following sub-item:
ME Firmware Version
ME Firmware Mode
ME Firmware SKU
PTT Capability / State
TPM Device Selection
Use this item to select TPM device.
The optional settings: [dTPM]; [PTT].
* Warning!
PTT/dTPM will be disabled and all data saved on it will be lost.
Firmware Update Configuration
Press [Enter] to make settings for
‘
Me FW Image Re-Flash
’.
Me FW Image Re-Flash
Use this item to enable or disable Me FW Image Re-Flash function.
The optional settings: [Disabled]; [Enabled].
* Note:
In the case that user needs to update Me firmware, user should set
‘Me FW
Image Re-Flash
’ as [Enabled], save the settings and exit. The system will turn off
and reboot after 4 seconds. If the user goes to BIOS screen again will find this item
is set again as [Disabled], but user can still re-flash to update firmware next time.
Trusted Computing
Press [Enter] to enable or disable Security Device Support.
Configuration
Security Device Support
Use this item to enable or disable BIOS support for security device. TCG EFI
protocol and INT1A interface will not be available.
The optional settings: [Disabled]; [Enabled].
►
ACPI Settings
Press [Enter] to make settings for the following sub-items:
ACPI Settings
