1-4
Intel® Integrated RAID Controller GSU31 User’s Manual
Rev 1.0
Quick Start Instructions
Figure 1-2. GSU31 Adapter Card
1.5
Create a Bootable RAID Volume Using RAID
Configuration Utility
A RAID volume (or logical drive) must be set up prior to installing the operating system. The
volume created in this step will host the operating system. Ensure that the volume’s size is large
enough to contain the operating system. The volume may contain more than just the host operating
system if desired.
Note:
The RCU can only configure one RAID volume at a time. If more than one RAID volume is
needed, refer to the
. By default, the RCU uses all disks
Internal 68-pin Connector
External VHDCI Connector
Intel® i960® RS I/O Processor
100 MHz Core
Flash Recovery
(FRU) Jumper
PCI 32-bit, 33MHz
Ultra160 SCSI
LSI Logic SYM53C1000
FRONT VIEW
Backplate Screws
Backplate
16Mb Flash
SDRAM
16 MB
Unbuffered, PC 100, ECC
BACK VIEW
