Intel AXXRMFBU4, Быстрая установка руководство пользователя

Страница: 8 / 13

4
General Installation Process
8
Reinstall the RAID Controller on the
Motherboard (Valid for Remote Mount
Board)
A
Make sure that the power to the chassis is still turned off, the power
cords are unplugged, and the chassis is grounded and has no AC
power.
B
Install the RAID controller in a PCIe slot on the motherboard, as
shown in the following figure.
C
Press down gently, but firmly, to seat the card correctly in the slot.
D
Secure the RAID controller to the computer chassis with the bracket
screw.
NOTE: This RAID controller is a PCIe x8 card, and it can
operate in x8 or x16 slots. Some PCIe slots, however, support
only PCIe graphics cards; if a RAID controller is installed in
one of these slots, the RAID controller will not function. Refer
to the guide for your motherboard for information about the
PCIe slot.
Intel ® RAID Controller
RS3DC080 as shown
Press
Here
Edge of
Motherboard
PCIe Slot
Bracket
Screw
Press
Here
Remote Mount
Board
RMFBU4 module
Super Capacitor Pack
module
7
Connect the RMFBU4 Module to the
Remote Super Capacitor Pack Module
(Valid for Remote Mount Board)
A
Ground yourself, and make sure that the system is grounded.
B
Place the RAID controller on a flat, clean, static-free surface.
C
Remove the cable that is included in the RAID controller box.
D
Insert one 9-pin cable connector on the cable into the 9-pin J1
connector on the RMFBU4 module, as shown in the following
figure (the cable is blue).
E
Insert the other 9-pin cable connector into the 9-pin connector on
the remote Super Capacitor Pack module.
Align the cable connectors to make sure that they are connected
correctly.
Intel ® RAID Controller
RS3DC080 as shown
J1
RMFBU4 module
Super Capacitor Pack
module
Remote Mount
Board