80960HA/HD/HT
Datasheet
41
I
CC5
Current on
the VCC5
Pin
80960HA
80960HD
80960HT
200
200
200
µA
9
C
IN
Input Capacitance for:
PQ4
PGA
12
12
pF
pF
F
C
= 1 MHz
10
C
OUT
Output Capacitance of each
output pin
12
pF
F
C
= 1 MHz
3
,
10
C
I/O
I/O Pin Capacitance
12
pF
F
C
= 1 MHz
10
R
PU
Internal Pull-Up Resistance
for ONCE, TMS, TDI and
TRST
30
65
100
k
Ω
NOTES:
1. I
CC
Maximum is measured at worst case frequency, V
CC
, and temperature, with device operating and
outputs loaded to the test conditions described in
Section 4.7.1, “AC Test Conditions” on page 45
.
2. I
CC
Typical is not tested.
3. Output Capacitance is the capacitive load of a floating output.
4. Measured with device operating and outputs loaded to the test conditions in
Figure 8, “AC Test Load” on
page 45
. Input signals rise to V
CC
and fall to V
SS
.
5. I
CC
Active (Power Supply) value is provided for selecting your system’s power supply. It is measured using
one of the worst case instruction mixes with V
CC
= 3.45 V. This parameter is characterized but not tested.
6. I
CC
Active (Thermal) value is provided for your system’s thermal management. Typical I
CC
is measured with
V
CC
= 3.3 V and temperature = 25°C. This parameter is characterized but not tested.
7. I
CC
Test (Power modes) refers to the I
CC
values that are tested when the 80960HA/HD/HT is in Reset mode
or ONCE mode with V
CC
= 3.45 V.
8. Worst case is V
CC
= 3.45 V, 0 °C.
9. I
CC5
is tested at V
CC
= 3.0 V, VCC5 = 5.25 V.
10.Pin capacitance is characterized, but not tested.
Table 22. 80960Hx D.C. Characteristics (Sheet 2 of 2)
Per the conditions described in
Section 4.3, “Recommended Connections” on page 38
.
Symbol
Parameter
Min
Typ
Max
Units
Notes