Intel 440GX страница 37 Скачать руководство пользователя

Страница: 37 / 118

Intel

440GX AGPset Design Guide

2-13

Motherboard Layout and Routing Guidelines

Section 2.7, “Timing Analysis” on page 2-17

describes the timing analysis for the 100 MHz host

bus in more detail.

Table 2-4

provides recommended flight time specifications for single and dual

Intel

Pentium

II processor systems. Flight times are measured at the Intel

Pentium

processor edge fingers. See the Pentium

II Processor Developer’s Manual

(order number 243502), Chapter 8, “GTL+ Interface Specifications“, for information on GTL+
timing measurements and signal quality specifications.

2.3.9

Topology Definition

GTL+ is sensitive to transmission line stubs, which can result in ringing on the rising edge caused
by the high impedance of the output buffer in the high state. GTL+ signals should be connected in a
daisy chain, keeping transmission line stubs to the Intel

440GX AGPset under 1.5 inches. Intel

Pentium

II processors should be placed at the end of the bus to properly terminate the GTL+

signals.

For a single Intel

Pentium

II processor design, Intel recommends that termination resistors be

placed at the other (AGPset) end of the bus. This provides the most robust signal integrity
characteristics and maximizes the range of trace lengths that will meet the flight time requirements.
The recommended termination resistor value is 56

Ω

± 5%.

For dual Intel

Pentium

II processor based designs, a termination card must be placed in the

unused slot when only one processor is populated. This is necessary to ensure that signal integrity
requirements are met. Refer to Slot 1 Bus Termination Card Design Guidelines for details.

2.3.10

Pre-Layout Simulation (Sensitivity Analysis)

After an initial timing analysis has been completed, simulations should be performed to determine
the bounds on system layout. The layout recommendations in

Section 4, “Debug

Recommendations” on page 4-1

are based on results of pre-layout simulations conducted by Intel.

GTL+ interconnect simulations using transmission line models are recommended to determine
signal quality and flight times for proposed layouts. Recommended parameter values can be
obtained if your supplier’s specific capabilities are known. The corner values should comprehend
the full range of manufacturing variation. Intel

Pentium

II processor models include the I/O

buffer models, core package parasitics, and substrate trace length, impedance and velocity. Intel

440GX AGPset models include the I/O buffers and package traces. Termination resistors should be
controlled to within ± 5%.

2.3.11 Simulation Methodology

Pre-layout simulation allows the system “solution space” that meets flight time and signal quality
requirements to be understood before any routing is undertaken. Determining the layout
restrictions prior to physical design removes iteration cycles between layout and post layout
simulation, as shown in

Figure 2-13

Table 2-4. Recommended 100 MHz System Flight Time Specs

Driver

Receiver

flight,min

[ns]

flight,max

[ns]

Intel

Pentium

processor

AGPset