5
Integra
®
Luxtec
®
UltraLite® Plus Headlight
Assembly of the UltraLite
®
Plus Headlight System
The UltraLite® Plus headlight assembly consists of a headlight with a variable spot module, a cushioned headband or
sweatband, bifurcated fiber optic cable and two gown clips.
Assembly
To assemble, attach the headlight module by sliding the bottom of the module
clip into the module receptacle, then push the top in until it makes an audible
”snap” (Figure 1). To attach the joystick, thread it into the hole in the front of the
headlight module.
To attach the fiber optic cable, insert the angled end of the cable into the
headlight module until it snaps into place (Figure 2). A bifurcated cable fits into
the cable clips on both sides and the rear of the headband or sweatband (Figure 3).
Remove the cable from the module by grasping the body of the module in one hand and the lower-most ridges of the
cable in the other hand and pulling them axially apart. Do not hold the cable by its leg(s) or strain relief.
Remember, the cable is made of glass fibers. When adjusting the cable on the headband, do not bend the cable more than 60
degrees. The cable is designed to curve gently around the shape of the headband.
All illustrations are representative and may not reflect your actual model and accessories.
