Integra DTR-40.2, Инструкция по эксплуатации

Страница: 79 / 104

79
En
Controlling Zone 2 with the Remote
Controller
Note
• To control Zone 2, you must press the remote controller’s
Zone2 first.
• Zone2 turns red while Zone 2 is on.
Note
• Only analog input sources are output by the ZONE 2 PRE OUT
and FRONT WIDE/ZONE 2 L/R terminals. Digital input
sources are not output. If no sound is heard when an input source
is selected, check if it’s connected to an analog input.
• You cannot select different AM or FM radio stations for your
main room and Zone 2. The same AM/FM radio station will be
heard in each room. For example, if you have an FM station for
the main room, that station will also be used in Zone 2.
• When you connect Zone 2 speakers directly to the AV receiver,
listening modes that require surround back speakers or front high
speakers or front wide speakers (6.1/7.1), such as Dolby Digital
EX, DTS-ES, THX Select2 Cinema, Dolby Pro Logic IIz
Height, and Audyssey DSX™ are unavailable.
• When the input selector of Zone 2 is selected, power consump-
tion on standby mode slightly increases.
• While Zone 2 is on, u functions will not work.
Adjusting the Volume for Zone 2
Muting Zone 2
Adjusting the Tone and Balance of Zone 2
Note
• Zone 2 can also be unmuted by adjusting the volume.
• The Zone 2 volume, tone, and balance function have no effect on
ZONE 2 PRE OUT when the “ Zone 2 Out ” setting is set to
“ Fixed ” (
➔
78 ).
1
Press Zone2 , then point the remote controller at
the AV receiver and press
On
.
Tip
• The
12V TRIGGER OUT
goes high (+12 V).
2
To select an input source for Zone 2, press
Zone2
,
followed by Input Selector .
To select AM or FM, press Tuner input selector and
Zone2 .
(North American models) You can also select SIR-
IUS.
3
To turn off Zone 2, press
Zone2
, followed by
Standby .
Zone2
Standby
On
Input
Selector
On the remote controller, press Zone2 , and then
use VOL q / w .
On the AV receiver, press Zone 2 Level Up
q
/
Down
w
.
On the remote controller, press
Zone2
, and then
press Muting .
To unmute a zone, on the remote controller, press
Zone2
, and then press
Muting
again.
1
On the AV receiver, press Zone 2 .
2
Press the AV receiver’s
Tone
to select “Bass”,
“Treble” or “Balance”.
3
Use –/+ to adjust the bass, treble or balance.
• You can boost or cut the bass or treble from –10 dB
to +10 dB in 2 dB steps.
• You can adjust the balance from 0 in the center to
+10 dB to the right or +10 dB to the left in 2 dB
steps.