Integra DTR-40.2, Инструкция по эксплуатации

Страница: 78 / 104

78
En
Note
• This procedure can also be performed on the AV receiver by
using Setup , arrows, and Enter .
■
Zone 2 Out

Fixed :
The Zone 2 volume must be set on the amp in that
zone.

Variable :
The Zone 2 volume can be set on the AV receiver.
If you’ve connected your Zone 2 speakers to an amp with
no volume control, set the “
Zone 2 Out ” setting, respec-
tively, to “ Variable ” so that you can set the volume, bal-
ance, and tone of zone 2 on the AV receiver.
■
Zone 2 Maximum Volume

Off , 50 to 99 (Absolute display)

Off , –32dB to +17dB (Relative display)
With this setting, you can limit the maximum volume for
Zone 2.
■
Zone 2 Power On Volume

Last , Min , 1 to 99 or Max (Absolute display)

Last , –
Q
dB , –81dB to +18dB (Relative display)
This setting determines what the volume will be for
Zone 2 each time the AV receiver is turned on.
To use the same volume level as when the AV receiver was
last turned off, select “
Last ”.
The “ Zone 2 Power On Volume ” cannot be set higher
than the “ Zone 2 Maximum Volume ” setting.
This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust the
volume for Zone 2.
Controlling Zone 2 from the AV receiver
Note
• When Zone 2 is turned off, the output from the 12V TRIGGER
OUT goes low (0 volts).
Setting the Multi Zone
1
Press
Receiver
followed by
Setup
.
The main menu appears onscreen.
Tip
• If the main menu doesn’t appear, make sure the appropri-
ate external input is selected on your TV.
2
Use q / w to select “Hardware Setup”, and then
press
Enter
.
The “ Hardware Setup ” menu appears.
3
Use
q
/
w
to select “Multi Zone”, and then press
Enter .
The “ Multi Zone ” menu appears.
4
Use
q
/
w
to select an item, and use
e
/
r
to change
it.
The items are explained below.
5
Press Setup .
The setup menu closes.
7. Hardware Setup
1. Remote ID
2. Multi Zone
3. Tuner
4. HDMI
5. Auto
Power Down
6. Network
7. Firmware
Update
7-2. Multi Zone
Zone2 Out
Zone2 Maximum Volume
Zone2 Power On Volume Fixed
Off
Last
Using Zone 2
1
To turn on Zone 2 and select an input source, press
Zone 2 followed by an input selector button
within 8 seconds.
Zone 2 turns on, the Zone 2 indicator lights.
Tip
• 12V TRIGGER OUT goes high (+12 V).
To select AM or FM, press
Tuner
input selector and
Zone 2 repeatedly.
(North American models) You can also select SIR-
IUS.
To select the same source as that of the main room,
press
Zone 2
twice. “ Zone 2 Selector: Source ”
appears on the display.
2
To turn off Zone 2, press
Off
.
The zone is turned off, and the
Zone 2
indicator
goes off.
Zone 2 indicator
Input selector buttons
Zone 2
Off