En-11
Connections
Connecting the AV
Receiver
Speaker Configuration
The following table indicates the channels you should use
depending on the number of speakers that you have.
No matter how many speakers you use, a powered
subwoofer is recommended for a really powerful and solid
bass.
To get the best from your surround sound system, you need
to set the speaker settings automatically (
manually (
*1
If you’re using only one surround back speaker, connect it to
the
SURR BACK or FRONT HIGH L
PRE OUT
terminals.
*2
Front high and surround back speakers cannot be used at the
same time.
Connecting the Speaker Cables
The following illustration shows how to connect the
speakers to each pair of terminals.
Tip
• You can specify whether surround back or front high speakers are
connected in the “Speaker Configuration” menu (
) or
during Audyssey 2EQ
®
Room Correction and Speaker Setup
(
).
Connecting Your Speakers
Number of speakers
2 3 4 5 6 7 7
Front speakers
✔ ✔ ✔ ✔ ✔ ✔ ✔
Center speaker
✔
✔ ✔ ✔ ✔
Surround speakers
✔ ✔ ✔ ✔ ✔
Surround back speaker
✔
Surround back speakers
✔
Front high speakers
✔
■
7.2-channel playback
Connect your Power amplifier’s analog audio input jacks
to the AV receiver’s
SURR BACK or FRONT HIGH
L/R
PRE OUT
jacks with audio cables.
If you’re using only one surround back speaker, connect it
to the
SURR BACK or FRONT HIGH L
PRE OUT
terminals.
■
Screw-type speaker terminals
Strip 1/2" to 5/8" (12 to 15 mm) of insulation from the ends
of the speaker cables, and twist the bare wires tightly, as
shown.
■
Banana Plugs (North American models)
• If you are using banana plugs, tighten the speaker
terminal before inserting the banana plug.
• Do not insert the speaker code directly into the center
hole of the speaker terminal.
AUDIO
INPUT
L
R
Front left
Center
Surround
right
Front right
Surround back/
Front high right
Surround back/
Front high left
Surround
left
Power amplifier
1/2" to 5/8" (12 to 15 mm)
Содержание DTR-20.4
Страница 1: ...AV Receiver DTR 20 4 Instruction Manual...