Instron 1000KPX-J3, Руководство по концепции системы

Страница: 47 / 58

47
Frame
Product Support: www.instron.com
Troubleshooting
In the event that problems arise during operation of the system, refer to Table 9 for help in determining
the specific problem and its solution. If the problem cannot be determined through the chart, contact
your local Instron Services department as directed on page
14 . Another option would be to check the
listing of Frequently Asked Questions (FAQs), available on the Instron website ( www.instron.com ), for a
description/solution to your problem.
Table 9. Troubleshooting the KPX system.
No. Possible Indications Possible Problem Solution
1
•
The indicators on the
SERVICE
display do not light when the system
disconnect switch is turned on
•
Frame power is lost for no apparent
reason
•
Test aborts and HPS shuts down
•
Frame will not enable
•
An interlock error message appears
in the controlling software
Frame and/or 59 Series control
unit are not receiving power
•
Check incoming power supply for
both frame and control unit
A fuse could be blown
•
Check all system fuses, refer to
“Replacement of fuses” on
page 54 .
2
•
HPS will not start Always verify that:
•
Computer is on
•
59 Series control unit is on
•
Controlling software is running
•
Frame is enabled
•
A test procedure/method is open
•
The load transducer is calibrated
Emergency Stop
engaged Disengage
Emergency Stop
button,
enable frame and start HPS
System disconnect switch not ON
( | ) Turn the disconnect switch to ON ( | ).
Overload protect circuit may have
tripped For assistance, contact your local Instron
Services department as directed on
page
14
If none of the above appear to be the problem:
•
For Partner systems, check the Status display for any abnormal
conditions or check the On-line Help for other helpful information
•
For Bluehill systems, check the Status Log for any abnormal conditions.
Click the Load Frame icon; the Status Log appears on the bottom portion
of the Load Frame tab.