www.instone3d.com
4
Instructions:
1. Connect to DC 5V-2A. Display "iNSTONE".
2. Press the OK button "√", and start heating automatically.
3. When the temperature up to the preset temperature value, press feed button
will feed continually or pause, double-press the button "<<" will feed
automatically; when the material come from nib, you can start to make your
design.
4. There are 3 modes for preset temperature and speed: "Low 85; Medium 90;
High 95". Press the OK button "√" to change the mode. You can select different
mode according to your own painting skills.
5. Press back button "
＞
" can retract the filament automatically, the pen will stop
in 5-10 seconds after retraction finished.
6. Long press the "√" button, when the preset temperature flashing, you can use
"<<"/ ">" to adjust the preset temperature.
7. The OLED screen will shut down automatically after 3 minutes if no use.
8. After use, put the pen on where children cannot get reach and don’t touch the
nib avoid scald.
