STEP 9
Install the safety flag
9A
9B
9C
Flag pole
9A.
Connect the flagpole sections and find the small opening near the top left edge of the canopy.
9B.
Slide the end of the flagpole through the opening in the canopy.
9C.
Slide the pole all the way down into the flag pole sleeve near the rear corner.
WARNING
Always use the safety flag when pulling this trailer!
STEP 10
Coupler attachment for bikes with rear hub nuts.
(Note: If your rear bike tire has a quick-release rear axle please proceed to Steps 12 & 13)
10A
10B
10C
10D
10A. Loosen the rear bike hub nut with a wrench.
10B. Remove the hub nut and washer from the bike.
10C. Slide the tab washer over the axle so the tab fits into the slot in the bike frame dropout.
10D. Position the coupler plate over the axle so that the pegs on the back of the plate fit into the
holes in the tab washer, and the coupler plate is vertical with the large hole below the axle.
STEP 11
Attach trailer tow bar to bike
11A
11B
11C
11D
11A. Replace the bike hub nut and washer and tighten by hand.
11B. Tighten the bike hub nut securely with a wrench.
11C. Insert the end of the trailer tow bar into the large hole and fasten the Q/R pin.
11D. Loop safety strap around bike frame and clip the end into the “D” ring at the end of the tow bar.
6
WARNING
Safety strap must attach to the bike frame when using this product in trailer mode.
