INSTEON Limited Warranty – INSTEON warrants to original consumer of this product for a period of 2 years from
date of purchase, this product will be free from defects in material and workmanship and will perform in substantial
conformity with its Owner's Manual. Warranty shall not apply to defects caused by misuse or neglect.
Protected under U.S. and foreign patents (see www.insteon.com) © Copyright 2012
INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845, www. Insteon.com
Quick Start Guide
SwitchLinc
™ Dimmer 240V, 50/60Hz (Dual-Band)
INSTEON
®
Remote Control Dimmer Switch
Model: 2478D
About SwitchLinc Dimmer 240V, 50/60Hz
Congratulations on purchasing the SwitchLinc Dimmer 240V. This
internationally-compatible version of our bestselling SwitchLinc Dimmer
features automatic 50/60Hz detection of the AC power frequency and flexible
100 - 277VAC support, allowing operation in a variety of electrical
environments.
Preparation
Installation should be performed only by a qualified electrician or by a
homeowner who is familiar and comfortable with electrical circuitry. If you have any questions regarding installation, we
suggest consulting an electrician. If you have any questions regarding setup, contact the INSTEON Support Line.
What’s in the box?
•
SwitchLinc Dimmer
• Four wire nuts
Tools Needed
•
Slotted screwdriver
• Phillips screwdriver
•
Wire cutter / stripper
• Voltage Meter
Installation
1) Turn off circuit breaker(s) or remove fuse(s) feeding wall box
2) Use a voltage meter to verify that power is off
3) Remove wallplate from switch and unscrew switch you are replacing and
gently pull out
4) Turn breaker(s) back on
5) Use a voltage meter to identify line and load wires connected to switch
6) Identify Neutral and ground wires
7) Turn breaker(s) back off
8) Connect wires as indicated. Confirm firm attachment with no exposed wire.
9) Gently place SwitchLinc into wall box, orienting unit with the LED bar on left
10) Screw SwitchLinc into place
11) Turn breaker(s) back on
SwitchLinc LED bar and connected light will turn on
12) Verify SwitchLinc is working properly by tapping SwitchLinc’s paddle
turning light (load) on and off
13) Reinstall the wallplate
Note:
For 3-way/4-way circuit installations, refer to the Owner’s Manual
Note:
When mounting in a multiple-ganged junction box, SwitchLinc
Dimmer is de-rated for 200-watts less for each immediately adjacent
dimmer installed. For example, 600W load control becomes 400W with
another dimmer to the immediate right or left. Use a triple-gang box with
a mechanical switch in the center to avoid de-rating.
SwitchLinc Wire Wall Box Wires
Bare copper
Ground
(commonly bare,
green wire or
green screw)
White
Neutral
(commonly
white)
Red
Load
(light, fan, etc.)
Black
Line
(100 - 277VAC
to Ground)
LED bar
brightness
indicators
Paddle top
(on/brighten)
Paddle bottom
(off/dim)
Set button
