Instar IN-9016 2K+, Руководство пользователя, Страница: 29 / 44

Go to https://install.instar.com
6-EN
4.3. Status LEDs
Status LED Blue LED Red LED
Constantly on Connected to WiFi N/A
Slow Flashing Connecting via WPS Camera at work
Fast Flashing No connection to WiFi Upgrading firmware
Off LED is turned off, or camera is
not plugged into power
LED is turned off, or camera is
not plugged into power
1 - Infrared LEDs 5 high-powered IR LEDs (nightvision @ 850nm) and 2 switch-
able status LEDs (blue and red, see description below)
2 - Lense Wide-angle (focal length: 4.3mm / field of view: ~ 90º dia.)
3 - Photosensor Twilight switch for IR LEDs
4 - PIR Detector Integrated Panasonic passive infrared (PIR) motion detector
5 - Microphone For noise detection / audio rec. / two-way audio intercom
6 - Audio Output 3.5mm jack for earphone / active speaker
7 - Network Port RJ45 LAN port / connector for Cat5e LAN cable or higher
8 - Power Connector For included 12V / 2A power supply
9 - MicroSD Card Slot Slot for MicroSD/SDXC cards (max. 128GB - 32GB included)
10 - WPS / Reset Three seconds for WPS WiFi setup / 20 seconds for reset
11 - Status LED Red: power; blue: network status (Please refer to Section 4.3)
12 - Antenna
Connector
RP-SMA WiFi antenna connector (not for PoE version)
13 - Antenna 2400-2500MHz: 3.5dBi
5150-5250MHz: 2.52dBi
5725-5850MHz: 1.90dBi
14 - IP66
Connector
For sealing cables with IP66 protection. Different scenarios
available for 1-cable, 2-cables, 3-cables
15 - Rubber-Joint 1-cable, 2-cable, 3-cable rubber-joint for different connection
purposes. (Please refer to Section 4.4 for more details)
16 - IP66 Nut To close the IP66 connector and to seal the rubber ring
17 - Bracket For wall mounting and overhead installation