Go to http://install.instar.com
6-EN
4.3. Status LEDs
01 - Photosensor
Twilight switch for IR LEDs
02 - Lens
Wide-angle (focal length: 4.3mm / field of view: ~ 90º dia.)
03 - Infrared LEDs
10 IR LEDs (nightvision @ 850nm)
04 - PIR Detector
Integrated passive infrared motion detector
05 - Loudspeaker
Integrated loudspeaker
06 - MicroSD Card Slot
Slot for MicroSD/SDXC cards (max. 128GB - 16GB included)
07 - Microphone
For noise detection / audio rec. / two-way audio intercom
08 - Power Connector
5V / 2A DC - Plug Ø : 1.35mm (in) / 3.5mm (out)
09 - WPS / Reset
3 seconds for quick WiFi setup / 15-20 seconds for reset
10 - Alarm In/Out
Input for potential free external alarm sensors
Output (relay) can support max. 24V/1A
11 - Antenna Connector RP-SMA WiFi antenna connector (not for PoE version)
12 - Network Port
RJ45 LAN port / connector for Cat5e LAN cable or higher
13 - Audio Output
3.5mm jack for earphone / active speaker
14 - Status LED
Red: power; blue: network status (both can be turned on/off)
15 - Mount
Standard camera thread for included stand (1/4”-20 UNC)
16 - Camera Label
P2P ID, LAN MAC address and serial number
Status LED
Blue LED
Red LED
Constant on
Connected to WiFi
N/A
Slow Flashing
Connecting via WPS
Camera at work
Fast Flashing
N/A
Upgrading firmware
Off
LED is turned off, or camera
is not plugged into power
LED is turned off, or camera
is not plugged into power