Warnings!
15kg
30kg
50kg
Rack-Mounted Server
Installation Guide
V1.0
For devices ≥ 15kg, it requires at least 2 people.
For devices ≥ 30kg, it requires at least 3 people.
For devices ≥ 50kg, it requires at least 4 people.
Please keep this document for future reference.
V015039000000000
机架式服务器
上架安装指南
V1.0
Watch out for the scratches that may be caused by the cabinet, chassis or
rails.
机柜或者服务器机箱、导轨可能造成划伤！在正在使用的机柜中安装新服务器时，请
谨防触电！
Be aware of electric shock when installing the servers into the cabinet in
use.
在正在使用的机柜中安装新服务器时，请谨防触电！
DO NOT block the vents on the server during installation, especially the vents on the front and
rear of the server.
安装时请注意不要阻塞服务器上的通风孔，尤其是服务器前、后部的通风孔。
Remove the protective film from the chassis before installing servers into the rack.
请在使用之前将服务器外壳上的保护膜撕去。
For proper ventilation, leave a minimum space of 15cm between two servers.
服务器的前、后部需至少留出15厘米空间，以便于系统散热。
For easy access of the front and rear ports and cabling, leave a minimum space of 70mm
between the front side of the server and the inner side of the cabinet’s front door, and 150mm
between the rear side of the server and the inner side of the cabinet’s rear door.
为了便于使用服务器前、后部的接口，并便于布线，服务器前部与机柜前门内侧之间至少留出70毫米、后
部与机柜后门内侧之间至少留出150毫米距离。
Always keep the air baffles in place to ensure proper air flow and avoid air turbulence in the
server room.
没有安装设备的机柜位置，请始终安装挡风盲板，以确保服务器获得足够的气流，并避免机房气流紊乱。
Installation must comply with local and regional electrical regulations. To reduce the risk of
personal injury, fire, or damage to the server, DO NOT overload the AC supply that provides
power to the rack.
安装必须符合当地电气法规。为避免人身伤害、火灾或服务器损坏，切勿让机柜中的交流电源分支电路过
载。
Servers can only be deployed in dedicated cabinets with ventilation holes or specialized cooling
cabinets to avoid server failure from overheating as they are high power appliances.
服务器是高功耗电器，只能安装在带有通风孔的专用机柜，或者专业水冷机柜中，以免过热造成系统失效。
In case of multiple-server deployment, always load from bottom to top and place the heavier
server on the lower bay.
如果要安装多台设备，请先从机柜靠下的空位开始，并将较重的设备安装在机柜下部。
DO NOT install devices beyond the cabinet’s load-bearing capacity, power supply capacity and
heat dissipation capacity.
请注意机柜的承重、供电及散热能力，切勿安装超出机柜承载能力的设备。
