8
ASSEMBLY INSTRUCTIONS
STEP 1:
A. Take out the pre-assembled Front and Rear Base A-Frame (1 & 2). Extend the Frame legs so
the A-Frame is fully opened. Make sure the center bars (11L & 11R) are completely in their
down positions.
B. Attach 2x Connect Sheets (4) to the Backrest Support Frame (3) as shown. Make sure the
Connect Sheets are securely affixed in their housings on the Backrest Support Frame. Place
2x Screws M6x10 (17) and 2x Lock Nuts M6 (21) at the hole in the bottom of the Connect
Sheet. This will help ensure the Sheet does not slide through its housing in case of accidental
dislodging.
C. Using the slotted round tops of the attached Connect Sheets, insert the Backrest Support
Frame into the cradles on top of the A-Frame. Once attached, secure the Connect Sheets to
the Support Frame with 2x Lock Pins 6xL43 (5).
NOTE:
Make sure to attach Part 4 as shown above, with the ends pointing towards the ground and the
grooved sections resting securely in the A-Frame. If you are uncertain which adjustment hole in the
Connect Sheet to use, you can start with the center hole and adjust later if necessary.