6
January 2017
Cover Installation:
(refer to chair diagram on page 4)
•
Pull on the back angle adjustment pull handle (A)
to set the backrest support to the most upright
position (Fig. 3). Slip cover over the back rest
and adjustment pull handle (Fig. 4). Wrap the
velcro straps around the seat frame and secure
underneath the seating (Fig. 5).
Adjusting Back Angle:
1. Locate the adjustment pull handle (A) on the back
of the chair under the cover (it is not necessary
to remove the cover to operate the lever). Using
both hands, grip the lever and back frame and
squeeze together.
2. With a lifting motion, adjust the back angle up or
down.
NOTE: Back angle should not be adjusted
when the chair is occupied.
Adjusting Calf Support Angle:
1. On the calf support frame, under the cover,
locate the adjustment pull handle (F). It is not
necessary to remove the cover. Using both
hands, grip the pull handle and calf support
frame and squeeze together.
2. With a lifting motion, adjust the angle up or down.
Note: The legs can be positioned at 0°
(horizontal), 30°, and 60° angles (relative to the
seat’s horizontal plane).
The legs SHOULD NEVER be in a complete 90° angle (perpendicular
to the seat’s horizontal plane). Leg angles greater than 60° will
cause the chair to be unstable.
COVER INSTALLATION AND ANGLE SETTINGS
Figure 3
Figure 4
Pull
handles
Figure 5
