3
4
2.1Choose the right connection cable according to the viewing
workpiece. This product is supplied with a rigid 1m long and
12mm diameter cable, and if need to change to other types of
connection cables, please loosen the nut anticlockwise and
remove the cable (see below picture).
Connect the AC/DC adapter to the DC in port of main unit, and the
input voltage is 110-220V. The “ ” in the right corner would blink
when charging (see below picture).
2.2Press the “on/off” 3-5 seconds to turn on, and the screen
display about 5 seconds.
will
2.3Move the lens to the viewing workpiece and adjust the
distance between 20-50mm (focus distance), and the rate would
be larger if the distance is much smaller during this range, and
the biggest magnification is about 28X. Adjust the LED
brightness to make the view more clearly.
remove
the cable
mount
the cable
locating slot
When display “ ” and the battery do not change means the battery
is full charged (see below picture).
Charge
：
blink
2.4
The
angle
of side view
is 54°, and to observe internal wall of
holes, install a 45° mirror is necessary, and 30° and 60° mirror
is also available for other views.
Attention: It is common the lens burning hot when LED light up
for a long time. The lens can also put into water or oil, and the
waterproof probe is IP65.
Operation
When mounting
slot (see below picture), then tighten the nut.
the cable, take attention of the place of the locating
focus distance: 20~50mm
angle of view: 54°
If display low battery in the right corner, please charge or
replace the lithium
battery.
full charged
Can install mirror, hook and magnet for better observation.
20~50mm
54°
45° mirror (optional)
hook (optional)
magnet pick up(optional)
