Service/Maintenance Instructions
Adjusting Temperature
The thermostat is pre-set at the factory. If a thermostat adjustment
is required, unplug the power cord and remove the screw and
access cover. Insert a small screwdriver in the slot of the thermo-
stat adjusting screw. Turn clockwise 1/2 notch to increase the
water temperature and counterclockwise 1/2 notch to decrease the
water temperature.
replace the access cover and reconnect electric power. Draw 3 or
cups of water and allow unit to heat. Repeat the process until
desired temperature is reached.
Do not allow water to boil.
What to do if something
goes wrong
1. If the dispenser's flow of water slows or stops, make sure the
water supply valve is not plugged or turned off. To unplug the
valve, turn it all the way off and then open it all the way. This
may dislodge any foreign material. If this does not work, then
unplug the power cord and contact your service center.
2. Be sure dispenser is plugged firmly into a properly grounded
outlet.
Check that fuses and circuit breakers are working. Reread
instruction booklet to assure that you are using correct
operating procedure. Many unnecessary service calls result in
the service agent doing what the owner can do for himself.
3. Contact your local authorized service center. For the location
of your nearest factory authorized service center call 1-800-
558-5700 USA (1-800-367-9811 Canada).
4. Write to us if a satisfactory solution Is not reached in the steps
above. Our address is shown below.
What if water is dripping from
the spout?
If water drips from the spout, draw 2 or 3 cupfuls while unit is
heating. This will drain any water out of the unit's expansion
chamber. If water still drips prior to the automatic thermostat
shutting off (you can hear it), turn thermostat to a slightly lower
temperature setting. See thermostat adjustment procedure at
left.
If the water pressure occasionally drops below 20 pounds per
square inch (138kPa), the expansion chamber of the tank may
not be draining properly. In such a case, water may drip from
the spout until the incoming water is hot enough to turn off the
thermostat. As soon as adequate water pressure is restored,
the next drawing of water will clear the expansion chamber.
Occasional drops in water pressure will not harm the operation
of your unit.
NOTE: Use only mild cleaners to clean the dispenser spout and
plastic components. Use of cleaning agents containing acids,
alkalines and organic solvents will result in deterioration of
plastic components.
Full One-Year Warranty
Beginning from the date of installation through one year of use
in your home, we will repair or replace at no charge defects in
material or workmanship which appear in the dispenser. If your
dispenser is replaced rather than repaired, the warranty on the
new unit shall be for the duration of the remaining portion of the
original dispenser's warranty. Please call the nearest Factory
Authorized
Service Center when service is needed
.
For the location of your nearest factory authorized service cen-
ter, call this toll free number: 1-800-558-5700 USA (1-800-367-
9811 Canada).
This full one-year warranty applies only if the unit is installed in
accordance with these installation instructions, is used on
circuits and currents specified, and has had normal use and
service.
The foregoing warranty does not apply to damage or inopera-
tion resulting from accident, alteration, misuse, abuse, improper
installation, installation not in accordance with these instruc-
tions or local electrical and/or plumbing codes or shows evi-
dence of having been started up "dry". We do not assume any
responsibility for consequential damage.
IN-SINK-ERATOR DIVISION
EMERSON ELECTRIC CO.
4700 21st STREET
RACINE, WIS., 53406-5093
Part Number 42752
