A
B
FILL TANK & THEN CONNECT POWER
Run the water for at least 2 minutes to flush lines.
DO NOT plug in unit until
water flows from faucet
6
See Installation, Care & Use Manual for important cautions, warnings and dangers
Quick & Easy Steps to Instant
Hot
Water
Press
ALL
tubes in once again to ensure secure fit.
STEP
FINAL WATER CONNECTION
A
B
Brass Nut
Ferrule
STEP
copper
1/4" tube
copper
1/4" tube
For Technical Assistance
1-800-845-8345
A
B
C
MOUNTING THE TANK
INSTALLING THE FAUCET
C1300
leave 1/4"
exposed
Hang tank and
tighten screws
with only
1/2 turn
clockwise.
16" or less from
faucet base
and
30" or less
from standard
grounded outlet
DO NOT extend plumbing
or electrical lines
DO NOT overtighten
O-Ring
Tank
must be
mounted
level.
STEP
H778
Property Damage:
Make sure bends in
all water lines are smooth and unkinked,
with no pinching, twisting or blockage.
Pinched or blocked water lines may cause
damage to the dispenser tank.
STEP
CONNECTING FAUCET TO TANK
STEP
blue
tube
1
2
3
white
tube
clear
tube
A
B
PREPARATION
Typical Complete Installation
Turn off
cold water
supply
STEP
Hex Tool
(included)
Fiber
gasket
What You Should Know
Before Beginning
Starting the Installation Process
This is a quick reference guide. Please refer
to the complete Installation, Care & Use Manual
for specifics including warnings, cautions and
dangers. If after reading the troubleshooting
section, you still have questions about parts,
installation or warranty, please visit
www.insinkerator.com/foodservice or call
1-800-845-8345.
Please have the model and serial number of
your tank and faucet available when calling.
Visit www.insinkerator.com/foodservice for
assistance on many common questions.
•
A continuous electrical power source (not
controlled by a wall switch) is required to
power the unit.
•
Ensure that there is sufficient space to
fit the unit under the sink and around
existing
plumbing.
•
For both the C1300 and H778 faucets, a
1-1⁄4" – 1-1⁄2" sink hole is required.
Electric Shock Hazard:
This appliance MUST be grounded. Using an ungrounded appliance
can result in serious injury or death from electric shock. Improper connection of the equipment
grounding conductor can result in the risk of shock by electricity.
BEFORE INSTALLING REPLACEMENT DISPENSER
Personal Injury:
Unplug the tank. Depress
the dispenser handle for about one minute
so cold water can flow through the unit.
This cools the water for safer removal of
existing tank and dispenser. Remove the
drain plug on the tank bottom to empty all
remaining water.
A
Содержание Instant Hot Water Dispensers
Страница 1: ......