PREPARATION
Turn off water supply.
TANK MUST BE MOUNTED LEVEL
TO ENSURE PROPER OPERATION.
Mount tank vertically within
400mm or less of faucet water
lines and within 760mm or less of
a standard grounded outlet.
Use a pencil to mark locations
for two hanging screws.
1 2 3 4 5
STEP
1
CONNECT LINE
Attach inlet tube.
Attach outlet and
vent tubes to fittings.
3
1
2
Inlet
(blue)
Outet
(white)
Vent
(clear)
1 2 3 4 5
STEP
3
6.4mm
8mm
11mm
Leave 6.4mm for
hanging tank
MOUNT TANK
Screws provided are for use in
wood only. Use wall anchors
(not supplied) for installation
into drywall.
Pre-drill 3mm pilot holes.
Install screws leaving
6.4mm exposed.
Hang tank on screws.
Tighten screws 1/2 turn
clockwise.
DO NOT overtighten screws.
1 2 3 4 5
STEP
2
Hot
(red)
FILL TANK
Turn on water supply.
Activate the HOT handle
and hold it until water flows
from the spout
(approximately 1 to 2 minutes).
Run the water for at least
2 minutes to flush lines
(both the hot and cold handles
independently if applicable).
1 2 3 4 5
STEP
4
HWTF (tank used with filter):
2-year warranty
HWTank (tank used without filter):
1-year warranty
HWT-1H:
1-year
warranty
This warranty is provided by InSinkErator, a business unit of Emerson Electric
Co., (
or
“Manufacturer”
or
“we”
or
“our”
or
“us”
) to the original
consumer owner of the InSinkErator product with which this warranty is provided (the
), and any subsequent owner of the residence in which the
Product was originally installed (
“Customer”
or
“you”
or
“your”
).
InSinkErator warrants to Customer that your InSinkErator Product will be free from
defects in materials and workmanship, subject to the exclusions described below, for
the
“Warranty Period”
, commencing on the later of: (a) the date your InSinkErator
Product is originally installed, (b) the date of purchase, or (c) the date of manufacture
as identified by your InSinkErator Product serial number. You will be required to show
written documentation supporting (a) or (b). If you are unable to provide documentation
supporting either (a) or (b), the Warranty Period commencement date will be determined
by Manufacturer, in its sole and absolute discretion, based upon your InSinkErator
Product serial number.
What is Covered
This warranty covers defects in materials or workmanship, subject to the exclusions
below, in InSinkErator Products used by a consumer Customer for residential use only,
and includes all replacement parts and labor costs. YOUR SOLE AND EXCLUSIVE
REMEDY UNDER THIS LIMITED WARRANTY SHALL BE LIMITED TO REPAIR OR
REPLACEMENT OF THE INSINKERATOR PRODUCT.
What is not Covered
This limited warranty does not extend to and expressly excludes:
• Losses or damages or the inability to operate your InSinkErator Product resulting
from conditions beyond the Manufacturer’s control including, without limitation,
accident, alteration, misuse, abuse, neglect, negligence (other than
Manufacturer’s), failure to install, maintain, assemble, or mount the InSinkErator
Product in accordance with Manufacturer’s instructions or local electrical and
plumbing
codes.
• Wear and tear expected to occur during the normal course of use, including
without limitation, cosmetic rust, scratches, dents or comparable and reasonably
expected losses or damages.
In addition to the above exclusions, this warranty does not apply to InSinkErator
Products installed in a commercial or industrial application.
No Other Express Warranty Applies
This warranty is the sole and exclusive warranty provided to the Customer identified
above. No other express warranty, written or verbal, applies. No employee, agent,
dealer, or other person is authorized to alter this limited warranty or make any other
warranty on behalf of Manufacturer. The terms of this warranty shall not be modified by
the Manufacturer, the original owner, or their respective successors or assigns.
What we will do to Correct Problems
If your InSinkErator Product does not operate in accordance with the documentation
provided to you, or you have questions concerning your InSinkErator Product or how to
determine when service is needed, please see attached Service Agency List.
The following information must be provided as part of your warranty claim: your name,
address, phone number, your InSinkErator Product model and serial number, and if
necessary, upon request, written confirmation of either: (a) the date shown on your
installation receipt, or (b) the date shown on your purchase receipt.
Manufacturer or its authorized service representative will determine, in its sole and
absolute discretion, if your InSinkErator Product is covered under this warranty. You will
be given the contact information for your closest authorized InSinkErator Service Center.
Please contact your InSinkErator Service Center directly to receive in home warranty
repair or replacement service. Only an authorized InSinkErator service representative
may provide warranty service. InSinkErator is not responsible for warranty claims arising
from work performed on your InSinkErator Product by anyone other than an authorized
InSinkErator service representative.
If a covered claim is made during the Warranty Period, Manufacturer will, through its
authorized service representative, either repair or replace your InSinkErator Product.
Cost of replacement parts or a new InSinkErator Product, and cost of labor for repair
or installation of the replacement InSinkErator Product are provided at no cost to you.
Repair or replacement shall be determined by Manufacturer or its authorized service
representative in their sole discretion. All repair and replacement services will be
provided to you at your home. If Manufacturer determines that your InSinkErator Product
must be replaced rather than repaired, the warranty on the replacement InSinkErator
Product will be limited to the unexpired term remaining in the original Warranty Period.
Limitation of Liability
TO THE EXTENT PERMITTED BY LAW, IN NO EVENT SHALL MANUFACTURER OR
ITS AUTHORIZED SERVICE REPRESENTATIVES BE LIABLE FOR ANY INCIDENTAL,
SPECIAL, INDIRECT, OR CONSEQUENTIAL DAMAGES, INCLUDING ANY ECONOMIC
LOSS, WHETHER RESULTING FROM NONPERFORMANCE, USE, MISUSE OR
INABILITY TO USE THE INSINKERATOR PRODUCT OR THE MANUFACTURER’S OR
ITS AUTHORIZED SERVICE REPRESENTATIVE’S NEGLIGENCE. MANUFACTURER
SHALL NOT BE LIABLE FOR DAMAGES CAUSED BY DELAY IN PERFORMANCE AND
IN NO EVENT, REGARDLESS OF THE FORM OF THE CLAIM OR CAUSE OF ACTION
(WHETHER BASED IN CONTRACT, INFRINGEMENT, NEGLIGENCE, STRICT LIABILITY,
OTHER SORT OR OTHERWISE), SHALL MANUFACTURER’S LIABILITY TO YOU
EXCEED THE PRICE PAID BY THE ORIGINAL OWNER FOR THE
INSINKERATOR PRODUCT.
The term “consequential damages” shall include, but not be limited to, loss of
anticipated profits, business interruption, loss of use or revenue, cost of capital or loss or
damage to property or equipment.
WARRANTY
CONNECT POWER
If no leaks, plug in tank.
Check for leaks around fittings.
1 2 3 4 5
STEP
5
Note: Gurgling or hissing is normal during initial heating cycle. Allow
12-15 minutes for water to reach desired temperature.
Note: For tap installation, refer to “Installation” section in the Use and
Care manual included with the tap.
NEW Tank Installation
| Instruction Sheet
Steaming Hot Water Taps
44666C Rev C
PARTS INCLUDED
19mm Screws (2)
• DO NOT
alter or remove the ground pin from power cord.
• Using an ungrounded appliance can result in serious injury or death
from electric shock.
• This appliance must be grounded – the power cord is equipped
with an equipment grounding conductor and a grounding pin. The
plug must be connected to an appropriate outlet, properly installed
and grounded in accordance with all local electrical codes and
ordinances.
Water must flow from faucet prior to plugging unit into electrical
outlet.
DO NOT
plug in yet.
NOTICE
Personal Injurt/Property Damage: Tank must be located within
400mm of faucet and within 760mm or less of a standard grounded
outlet. DO NOT extend plumbing lines or use an extension cord set
with this unit.
Snap connect fitting not included. Required when
replacing tank manufactured prior to January 2006. Call
the
AnswerLine®
1-800-558-5700 to order.
STOP
STOP
Note: Snap connect fitting not included.
WARNING
WARNING
