Insinger GW-40 BarMaster, Инструкции по установке, эксплуатации и обслуживанию

Страница: 14 / 38

OPERATING INSTRUCTIONS
PART 3 OPERATING INSTRUCTIONS
®
GW_40TM09 www.insingermachine.com 800-344-4802
Press the PRIME switch for the detergent and hold
it until there is detergent dropping into the fi ll box of
the Glasswasher sump.
Repeat for the Sanitizer and rinse-aid systems.
With the door(s) closed press the cycle start switch
(located near door handle on right side panel of
Glasswasher) (Double door units have cycle start
switches on both sides).
The following occurs:
Cycle light comes ON
Pump starts for the wash cycle
Detergent dispenses into
fi ll box.
After wash time is fi nished
Drain opens and water drains into the
external scrap screen and goes to the building
drain.
Drain closes
Sump
fi lls with water through the fi ll box.
Sanitizer dispenses into fi ll box
Rinse-Aid dispenses into fi ll box.
After fi ll cycle is fi nished
Pump starts for the rinse cycle
After rinse cycle is
fi nished
Cycle light goes OFF
Optional clean light (green) comes on and
stays on until a door is opened
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
START-UP AND CHECK
Before proceeding with the start up verify the
following:
Open the door(s) and verify that all packaging
materials and tie downs have been removed.
Verify that the scrap and pump screens are
properly located.
Verify that the drain stopper is closed and that the
linkage is free.
Check that the plugs are securely screwed into the
ends of the wash arms.
Check that the wash arm is securely screwed into
the base and that the arm rotates freely.
Check that the external scrap screen is installed.
Check the levels of all chemical containers.
Replace if necessary.
Verify that the incoming voltage is correct.
INSTALLATION START-UP PROCEDURE
Turn the glasswasher ON/OFF switch to the OFF
position.
Turn the Glasswasher DE-LIME switch to the OFF
position.
Turn the Glasswasher cycle time switch to the STD
position.
Turn the water supply to the unit ON and check for
leaks.
Turn the electric power supply to the glasswasher
ON
Turn the Glasswasher ON/OFF switch to the ON
position.
After a slight delay the water solenoid valve
opens and the glasswasher fi lls.
The cycle light will be on while the fi ll solenoid
is energized.
Con
fi rm water supply pressure. (22-24 psi)
After the fi ll solenoid valve shuts off check the
water level.
The water level should be at the lowest edge
were the back and bottom of the sump meet.
Adjust water level by adjusting incoming water
supply to 22-24 psi.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
NOTE:
Pump stops when door is opened but the
cycle continues
;
12