FIXED-POSITION WALL MOUNT FOR TVs 40-70 in.
11
www.insigniaproducts.com
STEP 5 -
Option 2: Installing on a solid concrete or concrete
block wall*
CAUTION:
To prevent property damage or personal injury, never drill into mortar between blocks.
Mount wall plate directly onto the concrete surface.
1
Align the wall plate template (
R
) at the height you determined in the previous step (or by using the
HeightFinder mentioned on the template), make sure that it is level, then tape it to the wall.
2
Drill pilot holes through the template to a depth of 3 in. (75 mm) using a 3/8 in. (10 mm) diameter
masonry drill bit, then remove the template.
3
Insert the concrete wall anchors**
into the pilot holes and use a hammer to make sure the anchors are
flush with the concrete surface.
4
Align the wall plate (
A
) with the anchors, insert the lag bolts (
P
) through the lag bolt washers (
O
), then
through the holes in the wall plate. Tighten the lag bolts only until they are firm against the wall plate.
CAUTION:
• Avoid potential injuries or property damage!
• DO NOT over-tighten the lag bolts (
P
).
**Not included. Call Customer Service to have the Fischer UX10 x 60 concrete anchor kit shipped directly to
you.
.
You’ll need
3 in.
(75 mm)
* Minimum solid concrete
thickness: 8 in. (203mm)
* Minimum concrete block size:
8 x 8 x 16 in. (203 x 203 x 406 mm).
* Minimum horizontal spacing
between fasteners cannot be less
than 16 in. (406 mm).
See
Note**
See
Note**
** Note
: Not
included. Call
Customer Service to
have the Fischer UX10
x 60 concrete anchor
kit shipped directly to
you.
P
(4)
Drill
3/8 in. concrete
drill bit
1/2 in. socket
wrench
Level
Wall plate (
A
)
O
(4)
Wall plate template (
R
)
Tape
Hammer
NS-TVMFP23-NS_TVMFP23-C_14-0745_MAN_V2_ENG.fm Page 11 Sunday, August 10, 2014 10:17 PM
