www.insigniaproducts.com
29
3-in-1 TV Stand
STEP 4: Option 1 - Mount the frame to a stud wall
If you are mounting the TV on a concrete or block wall, to go STEP 4: Option 2- Mount the frame to a block or concrete wall
on page 30.
You need:
1
Use a stud sensor to locate two adjacent wall studs, then position the mounting frame (
I
) exactly between the two
studs.
2
Use a level to make sure that the mounting frame is level, then mark the four mounting holes. Remove the mounting
frame.
3
Drill four 3/16" (4.8 mm) holes 2.5" (64 mm) deep using a drill with 3/16" a wood drill bit.
4
Align the mounting frame (
I
) with the pilot holes, then secure the frame to the wall with four lag bolts (
S
) and four
washers (
U
) using a socket wrench.
CAUTION:
Make sure that the lag bolts are tight and secure, but do not overtighten them.
Power drill
Edge-to-edge stud finder
Hammer
Pencil
Level
Socket wrench
3/16" wood drill bit
S
Lag bolt (4)
U
Large flat washer (4)
2.5"
(64 mm)
.2"
(4.8 mm
)
