www.insigniarange.com
Last Modified 07/10/2015
10
TO START
Make sure you have a clear space, remember when finished and in place you need access
to check your build and able to pull the shower out for servicing or should you have the need
to replace anything!
Take the shower tub and remove all the protective wrapping and fit the waste. In the side of
the waste supplied in the optional fitting kit you will notice a spigot not seen on an ordinary
waste. In most cases this is blanked yet should you have a steam version you need to gently
drill this out as this item is for the steam generator drainage and will be connected in the in-
structions later.
Now please level the tray by firstly placing the tray in its final location and then using a spirit
level, adjust the tray feet accordingly. Once you are happy with the levelling of the tray, you
can pull it out to begin the main construction.
Step 1
Place the mirrored back panel marked
“
left
”
to the side glass ensuring that the
side glass frame at its wide point is at the rear of the shower and wide black
decorative paint is at the top.
Align the back panel to lip on the side glass and once you are happy with the
alignment, run a bead of
silicone
up the edge and
Rubbergum
along the bottom
of the panels and screw together using the
ST20