www.insigniarange.com
Last Modified: 08/10/2015
17
Shelf
Fix the chrome floating shelf brackets to your glass back panel by using the provided screws. Now attach the chrome tubed bars to your glass shelf as illustrated in the
below image. Next slide the shelf into your shelf brackets and secure by tightening the grub screw situated on the bottom of the bracket.
Accessory Installation
Please Note
Ensure all grey backing film on the rear of the glass panels are pierced through the existing glass holes
with a knife to provide an efficient smooth fitting and location of the accessories. We recommend using
a screwdriver on the smaller holes.
Steam Pod
Insert the pod from the inside of the shower and at-
tach large white nut from the rear.
.
Thermostatic Probe
Insert the chrome sleeve into the hole situated below the
control panel and secure in place with the retaining nut.
Insert the rubber grommet into the sleeve and push the
probe through from the rear of the cabin ensuring the
probe protrudes no more than 6mm. Place a small
amount of silicone behind to fully secure in to place.
x2
Hand Shower
Attach the chrome riser bar to the glass wall ensuring the water inlet
is inserted through the lower large hole and hand tightened from the
rear side.
Now tighten the chrome shower holder ensuring that this will take
the hand shower itself without falling (please note over tightening
will prevent the holder from sliding up and down)
