2
3
1
4
NTC Temperature sensor 5m
LDR Light sensor 5m
Usermanual
Troubleshooting
If the Frequency Master fails to run:
1. Switch off the supply and check the fuse
(4)
in the Frequency Master.
2. If the fuse
(4)
is OK increase the minimum fan
speed.
3. Re-connect the Frequency Master and retry.
If the Frequency Master still fails please contact the
retailer the unit was purchased from.
Technical Specifications
Frequency Master 10Amp
Adjustable capacity
Max. 10Amp
Input
230v-240v 1Ph
Frequency
50Hz
Dynamic range
0.5 - 10.0Amp
Temp. sensor (NTC 5 meters)
4K7 at 25˚C
Light sensor (LDR 5 meters)
100K - 10 LUX
Have the Frequency Master
connected by a recognized installer.
- Make sure The Frequency Master is securely
attached to on a wall.
- Attach the NTC (if possible) in the middle of
your room.
- Connect the fan or fans. Fans of the same
m3 don’t give under pressure to your room.
Plug the Frequency Master into an earthed power
outlet.
Turn the left-hand knob
(1)
to the desired speed.
Minimum speed 20% to 60%. If the fans start to hum
gently, turn the left-hand knob
(1)
a little higher until it
is corrected. A to low fan speed can damage thefan
or fans or the Frequency Master.
Turn the right knob
(3)
to the desired
maximum speed (60% to 100%).
Now set the desired temperature with the
temperature knob
(2)
. The NTC now controls the
processor for optimum temperature control in your
room.
1
2
3
4
5
Usermanual
Frequency Master
10Amp
EN
Congratulations with the purchase of your Frequency Master Controller
The Frequency Master is a software-controlled climate controller. The Frequency Master is suitable for one
or two fans. The Frequency Master also has an LDR (light sensor) and NTC (temperature sensor).
5 YEAR Warranty
The Frequency Master product warranty(terms
& conditions), excludes faulty fuses. The
manufacturer shall not be responsible for any
damage caused by operation of the unit, be
it incidental or consequential; or of any type;
including, without limitation, damage or injury,
caused to other products, machinery, or buildings.
Nor will responsibility be accepted for loss of
time or profit, loss of finished products, or for any
inconvenience caused in any way whatsoever.
Switching the night mode on
Humidity can rise sharply during the night. To keep
this humidity within acceptable values, you can
choose to use the night mode. The STC switches
up in small steps to a Max 80%, twice per hour, for
a few minutes. Thereby lowering the moisture in
the air. When de rubber cap is removed from the
light sensor the STC will now operate in night/ day
mode. The green LED
(6)
will now light up. Showing
the STC is in night mode. Switching the night mode
off By turning the switch
(5)
to the zero position
and then waiting 5 seconds and then back to the
Automatic mode switchable mode
(1)
, the night
mode is switched off. The green LED
(6)
will now be
switched off.
Disposal
This unit is not suitable for disposal as or with
household waste. It should be taken to a local
recycling centre.
FR
ES
SQ
DE