InPower LLC
8311 Green Meadows Drive
Lewis Center, Ohio 43035
740-548-0965
www.InPowerLLC.com
© Copyright 2014 InPower LLC
ITM150 Owners Manual
Page
5 of 8
Document: OM-175
Version Code: B
Date: Feb. 28, 2014
Date: May 27, 2014
5. Wiring Instructions (cont.)
Circuit 2 Wiring (Park Brake)
1. Run the brown park brake wire under the carpet to the brake lever located on the door side of the
driver’s seat. Remove the cover held on by two screws. (See Figure 4)
2. Unplug park brake 1-pin terminal.
3. Connect the park brake T-harness.
Alternate Instructions for Splicing:
Splice the brown park brake wire from the interlock harness into the orange/white park brake wire lo-
cated on the BCM connector C6, pin 44.
Circuit 3 Wiring (Lift Door)
For side-sliding door:
Connect the violet wire found on the interlock harness to the side Door Ajar switch black/violet wire
(Figure 5). If you prefer to splice, the side door wire is located at BCM connector C6, pin 33 in the
passenger side stepwell. (Figure 6)
For rear door:
Connect the violet wire found on the interlock harness to the rear Door Ajar switch white/black wire.
If you prefer to splice, the rear door wire is at BCM connector C6, pin 35.
Figure 4. View of Park Brake terminals
Figure 5. View of Side Door Ajar switch
Figure 6. View of stepwell wiring and potential
splice site.
