INOXPA LM 1.10-4030-1-200, Инструкции по установке, обслуживанию и техническому обслуживанию

Страница: 12 / 24

Installation
12
INOXPA S.A.U.
20.025.30.01EN · (0) 2019/04
ANGULOS DE ATAQUE
Relación H/D 0,5 1 1,5 2 2,5 3 4 5
αº
0º 8º 14º 18º 25º 30º 40º 50º
Visc. máx cPS 3000 3000 1500 1500 500 300 150 100
FON
DO
S
º º º º - - - -
º º º º º º º º
º º º º º º º º
5.5. ELECTRICAL INSTALLATION
Before connecting the electrical motor to the mains, check local regulations on electrical safety as well as the
applicable standards.
Check the instructions manual of the manufacturer of the motor for information on how to connect it to the
mains.
Take the connection of the electrical motors must be performed by qualified personnel.
Take the appropriate measures to prevent any fault.
The motor must be provided with devices for protection against power overload and short-circuits.
The agitator cannot be used in areas where there is a risk of fire or explosion when this has not
been specified in the order.
5.6. ASSEMBLY
To situate and fit the agitator in the flange support of the tank, you should disassemble the propeller from the
shaft. Then, the agitator flange should be fitted on to the one of the tank screws placed in position in their
corresponding drilled holes, and the fit the nuts. When they are fully tightened, fit the propeller to the end of the
agitator shaft. Be careful, when assembling the agitator element not to knock the agitator shaft, to avoid any
distortion.
Force should never be applied to the end of the agitator shaft, as it can easily suffer permanent
damage.
Check the alignment of the agitator shaft with the half shaft once its assembly is completed.
ATTENTION
ATTENTION