Inovonics HD Radio SiteStreamer+ SOFIA 568, Инструкция по установке и эксплуатации

Страница: 33 / 44

— 31 —
As already stated, the SOFIA 568 can accommodate as many as
10 simultaneous Web listeners. This number can be truncated,
however, in the interest of better streaming service to fewer
authorized listeners. The
Max Listeners:
slider can be set be-
tween
0
and
10
.
Once changed,
Stream
settings must be saved by clicking on the
Save
bar. Note that this does reset the utility, disconnecting
any current listeners, who then must log back on.
General Purpose
Outputs
The rear-panel GPOs serve as ‘tally’ outputs for SOFIA 568
alarms. They give access to closures (or opens) to ground for
any four alarms selected from the field of 12.
Each GPO is programmed separately. The
Output #
numbers on
this Web interface page correspond to the four numbered ter-
minals on the back of the unit. +5V and ground are also pro-
vided on the terminal strip.
In the example shown
here,
Output 1
has been
Polarity:
-programmed to
deliver an
Active Ground
to GPO terminal 1 for an
alarm
Type:
of
Audio Loss
.
It could as easily have
been set to deliver ground on that terminal all the time, and
then go
Active Open
(ungrounded) when the alarm is received.
The
Status:
line in this example shows that
Output 1 is Inactive
;
that is, the assigned
Audio Loss
alarm has not been tripped.
Any of the 12 alarm conditions could have been assigned here
in the
Type:
field. Choose the four that are most important to
you and assign them to the four GPOs.
NETWORK SETUP AND INTERNET ACCESS
Obviously, if Web interface pages are appearing on your screen,
what follows must already have been addressed. Getting up-
and-running through front-panel setup was covered on Page 15,
so most information here may turn out to be redundant.
IP Setup
With
Mode:
set to
DHCP
, your router auto-
matically assigns the SOFIA 568 an
IP Ad-
dress:
and will populate the four associated
fields, although they will be ‘grayed-out’
and you’ll not be able to edit the data in
those fields. However, if
Mode:
is changed to
Static IP
, then you
must make the appropriate entries in all four fields.
Assigning a
Hostname
You may change the default name
SOFIA568
to something else,
either to personalize the equipment name or to differentiate
one SiteS from another on the same network.