9
4.2
Air/Water Syringe
•
To operate the Air/Water Syringe, press the power switch to ON, lift the syringe from the holder and depress
the respective button(s) on handpiece to obtain either air or water, or both.
4.3
Built-in Piezoelectric Scaler and Handpiece
•
To connect the Piezoelectric Handpiece to the cord, align the three pins and water supply port on the
handpiece with the cord. Insert the handpiece into the cord coupler, and gently, but firmly, push the
handpiece into the cord coupler. Do not twist, turn or unscrew the handpiece while inserting into or
removing from the cord coupler. This will break the connectors in the handpiece and cannot be repaired
and will void Warranty.
•
To operate the Piezoelectric scaler, press the Piezoelectric
power switch to ON, see diagram on Page 4 (Item 20). Lift the
Piezoelectric Handpiece from the holder, set the power dial
and water flow and press on the foot pedal. Water should
be adjusted to a fine mist (See Figure 4.8 and 4.9).
Figure 4.8
Figure 4.9
•
The built-in Piezoelectric scaling system power settings can be used in a range from 1 through 10 (1 being the
lowest setting and 10 being the highest). The procedure will determine the tip selected and power level
used. Refer to the table located on Page
10, “Po
wer Settings & Use of KLAW
™
ti
ps”,
for recommended power
settings.
Note:
If power range exceeds recommended settings below, this may cause tip breakage.
•
To disconnect the handpiece from the cord, hold the handpiece in one hand and the cord coupler in the
other hand, then pull apart (See Figures 8.3 and 8.4).
Do not pull on the cord!
Doing so will void Warranty.
After disconnecting the handpiece, it is recommended to use the Air/Water Syringe to blow any left over
water from the connector (See Figure 8.5). Water or fluid left in the cord coupler may render the unit
inoperative for future use.
Figure 4.10
Figure 4.10
Figure 4.11
Содержание Veterinary Dental Cart
Страница 4: ...4 2 High Speed Veterinary Dental Cart...
