J-box
door
clip
back plate
Step 1
Open the back box by using philips screw driver (FIG.2),Refer to size of the diagram to bore the
holes on the wall(FIG.1).
Step 2
screw the two green/yellow grounding cord to the position which indicated "GR"(FLG.3)
Step 3
Install the rear cover on the wall, connect the cable refer to the circuit diagram(FIG.5)
Step 4
Tighten enclosure screws to seal fixture. (FIG.4)
FIG.3
Dongguan Thailight Semiconductor Lighting Co., Ltd
Sanhui Ind. area, Cunwei, Hengli Town, 523000, DongGuan, GuangDong, China.
Supply Line(Black)
Supply Neutral(White)
Supply Grounding(Green)
Box Grounding(Green)
Neutral(White)
Line(Black)
LED DRIVER
Factory Wired
LED to Driver
FIG.4
Twist-on wire connector
Wiring layout without Photocell
After installation, please
check whether the lighting fixture is firmly fixed.
check whether wires are connected correctly.
At last, turn on the power, and check if the lighting fixture works well. If not, please turn off the
power and contact with local dealer.
Warning: the luminaire shall be installed by qualified electrician.
