Innovative Technology NV200S Spectral, Руководство пользователя

Страница: 94 / 96

User Manual – NV200 Spectral
<< Back to Contents
Copyright © Innovative Technology Ltd 2019
Doc: User Manual NV200 Spectral
Version: 2.1
Page 93 of
95
11.4 Connector Specifications
Type Vendor Part Number Pins Pitch Polarising
Housing Leotronics 2652-2161 2x8 2.54mm With Key
Crimp Leotronics 2653-2000 Female
Housing Molex 90142-0016 2x8 2.54mm With Key
Crimp Molex 90119-2121 Female
11.5 Switching to Programming Mode (SSP)
If fitted remove the Payout or Ticket modules. Power the NV200 Spectral, once the
unit has initialised toggle dip-switch 8 up and down.
To switch the unit back repeat the procedure explained above.
WARNING!
Risk of unit damage
When in programming mode and performing an
update, do not turn off the power before the
operation is complete as this could make the unit
unusable.
11.6 Free Fall Cashbox Advice
The NV200 Spectral cashbox and TEBS cash bag has been designed to remain intact
after an impact of 75cm onto a concrete floor. Dropping the cashbox multiple times
can result in physical damage to the cashbox/bag.
11.7 ccTalk DES Encryption – Trusted Mode
Ensure the NV200 Spectral has been configured to use DES encryption in Validator
Manager, this setting can be found on the options tab. To pair the NV200 Spectral
with a DES trusted machine follow the steps below:
1. Remove power from the unit then remove the cashbox
2. Re-power the unit, once the unit has started it should be in pairing mode.
If a Spectral Payout module is connected the unit must be empty before it can pair to the
host.
11.8 Escrow
The NV200 Spectral has a single note escrow facility. This allows the NV200 Spectral
to hold onto the note once validated, and only stack the note into a cashbox when
the host machine confirms that the Vend operation has been completed. If no
confirmation of the Vend is received, the note will be returned to the user after 30
seconds.
If the host machine itself aborts the transaction by sending the reject command
(0x08). Similar commands can be sent depending on the protocol used. For
information relating to other protocols contact support.
