iTroll Pro Staff Tip! Use Max function to rapidly let line out once bait “grabs” water. Watch
for strikes! - The falling bait often gets hit!
2.10: Last Idle Feature: Press the
Hunt
button to display the throttle level prior to idling
the motor in Step 2.7. Most often this is the speed where you last hooked a fish.
2.11: Hunt Enabled iTroll’s only - Enter Hunt Mode by first idling the motor by pressing
the
Idle
button. You then
HOLD
the
Hunt
Button down and then press and release the
On
button. It’s easy to remember this sequence as “Hunt On”’!
*** Section 3: Operation of iTroll in Hunt Mode ***
*** Hunt Enabled or Hunt Test Drive iTroll units only ***
If using Hunt Mode for the first time, you must set Hunt’s safety limits for
your particular boat - see sections 7 AND 8. Additionally, the Hunt parameters
initially programmed into your iTroll are very conservative and will most likely
need to be reprogrammed (step 3.2 below).
Hunt mode is accessed through Step 2.11 of manual control of the throttle, repeated here:
2.11: Hunt Enabled iTroll’s only - Enter Hunt Mode by first idling the motor by pressing the
Idle
button. You then HOLD the
Hunt
Button down and then press and release the
On
button. It’s easy
to remember this sequence as “Hunt On”’!
3.1: iTroll’s screen will show a summary of last stored Hunt parameters (described in Sec-
tion ). Press
Hunt
button to start Hunt Mode.
3.2: To change any of the Hunt Parameters OR any of the Hunt Limits, idle the motor by
pressing and releasing the
Idle
button. Press the
Hunt
and
Max
buttons
at the same time
and then reference Section 4 of these instructions.
3.3: You can jump to the next throttle step by pressing the
Hunt
button.
3.4: If you get a hook up, pressing the
Idle
button will put the motor at idle speed and
iTroll will display the throttle setting where the hook up occurred.
iTroll Pro Staff Tip! If it’s windy, when you idle the motor, the wind can drastically alter
the boat’s heading. You can exit Hunt Mode by pressing and releasing the off button
which returns you to manual throttle mode. You can then dial in just the right amount of
throttle to maintain your intended heading when an angler is fighting a fish. When fish is
relaeased or boated, return to Hunt via step 2.11.
3.5: Pressing the
Run
button will resume the Hunt program.
3.6: The
Max
button is used to apply a burst of power to rapidly let line out, raise lure
depth, set hook after a fish strike, or to apply extra power when needed to steer boat in
windy conditions. When Max button is released, Hunt Mode resumes.
3.7: To exit Hunt Mode and return to manual throttle control, simply press and release the
Off
button.
*** Section 4: Reprogramming Hunt Parameters ***
Hunt mode programming is accessed through Step 3.2 of Hunt Mode operation, repeated here:
3.2: To change any of the Hunt Parameters OR any of the Hunt Limits, idle the motor by pressing