Innova Srl
Page 30
N420220A_ManualeHRC_Rev07.EN
8
ACCESSORIES
The unit can be equipped with some installation accessories.
Carefully read the instructions below for installing each individual accessory.
8.1.1
DFM WALL FIXING TEMPLATE
The wall fixing template allows the unit to be removed
from the wall without the need to remove the wall fixing
screws.
The template is installed on the wall using screws and
plugs; the motor holder plate is then fixed on the
template which will be sucked in by the threaded
handwheels supplied.
To inspect the exchanger and the internal parts of the
pipe, it will not be necessary to remove the screws on the
wall, but only to remove the template locking
handwheels.
DFM - Installation of a wall fixing template
To inspect the exchanger and the internal parts of the
pipe, it will not be necessary to remove the screws on the
wall, but only to remove the template locking
handwheels.
Carry out the following operations with the appliance not
powered.
Then proceed by removing the lid with filter.
Release the four fixing clamps from their seat.
Unscrew the four template locking handwheels.
Paying attention to the wires, remove the motor holder
plate which will remain raised by the wires and will allow
cleaning of the exchanger and pipe.
Refit the motor holder plate, arrange the wires and
terminals; refit the cover with filter.
DFM - Exchanger and pipe inspection with DFM