7
S
I
U
EN
USER MANUAL
Key/Display
Operation
Fan speed control (models 8 and 10)
By pressing this button several times, the speed will change according to the following sequence: Minimum, Medium,
Maximum and Automatic
The higher the speed is set, the better the appliance will perform, but it will be less quiet. By selecting Automatic mode
(shown by three speed bars moving up and down on the display), the on-board microprocessor automatically adjusts
the speed, so that it stays higher the greater the difference between the temperature detected and the temperature
set. The speed will always be automatically decreased as the room temperature approaches the set temperature.
This is not possible in humidification only or nocturnal well-being mode where the appliance can only operate at a low
speed.
Setting power for models inverter 10HP and 12HP
By pressing this key sequentially, it is possible to set the power supplied by the appliance on 5 adjustments: Minimum,
Medium, Maximum, Dual Power and Automatic.
The higher the power is set, the better the appliance will perform, but it will be less quiet.
The Dual Power function (shown by three flashing speed bars on the display and the seven red or blue bars moving
up and down of the digital thermometer), available only in heating and cooling mode, supplies a 30-minute Overboost.
Then, the controller inhibits the function and switches to automatic mode.
By selecting Automatic mode (shown by three speed bars moving up and down on the display), the on-board
microprocessor automatically adjusts the speed, so that it stays higher the greater the difference between the temperature
detected and the temperature set. This is not possible in humidification only or nocturnal well-being mode where the
appliance can only operate at a low speed.
Setting the Timer function
•
The appliance allows the user to program when to turn it on and off, as required.
•
While the conditioner is running, it is possible to schedule when it turns off by pressing the Timer button, followed
by the number of hours (from 1 to 24), after which the unit will be put in stand-by.
•
When the air conditioning unit is off, it is possible to schedule when it turns on by pressing the Timer button,
followed by the number of hours (from 1 to 24) after which the unit will start.
•
Then, press the confirm button.
Touch-screen display key lock
•
The key lock is activated by keeping the Timer symbol on the touch-screen display pressed for three seconds.
The user cannot perform any actions. The stand-by symbol flashes every second.
•
To deactivate the lock, keep the Timer symbol on the touch screen pressed for three seconds once again.
The lock remains active in the case of a power failure and also if the remote control is used!