© MASS ELECTRONICS Pty Ltd 2006
Page 3
DS 15.09 - GENII CSAH REM - Control Station After Hours Module
August 2013
Program Functions On The GENII CSAH REM
Start Programming Mode
To enter Programming Mode depress and hold the
and
ON
OFF
buttons for 5 seconds. The display will become blank
indicating that you are in the Programming Mode. Release both
keys and the display will show parameter 0.
Whilst in the programming mode the following buttons are
active:
ON
OFF
Change to the next parameter.
Increase the current parameters value.
Decrease the current parameters value.
Parameter 0: Rem Address
The display will show current REM Address of the device.
• The range of address is 0 to 15
• The default address is 0
Parameter 1: Maximum Input Value
The display will show the Maximum Input Value to which the
module’s input can be set.
• The range of Maximum Input Value is 0.0 to 99.9
• The factory default setting is 30.0
Parameter 2: Minimum Input Value
The display will show the Minimum Input Value to which the
module’s input can be set.
• The range of Minimum Input Value is 0.0 to 99.9
• The factory default setting is 15
Exit Programming Mode
To exit the Programming Mode depress the
ON
OFF
and
buttons and the new setting will be saved.
Start Up Default Settings
The GENII CSAH REM Module can be set to start with a default
setpoint.
1. To set the start up default setpoint, adjust the GENII CSAH
REM Module to the desired setpoint and then press and
hold the
ON
OFF
and
buttons for 5 seconds.
2. The display will become blank indicating that the new
setpoint has been saved.
Operating Functions On The GENII CSAH REM
Numerical Output
The GENII CSAH REM Module will display a 3 digit, single decimal place
analogue output value during normal operation.
Numerical Input
The GENII CSAH REM Module will provide a 3 digit, single decimal
place analogue input value to the GENESIS Controller during normal
operation.
This value can be modified by pressing the
button to increment by
0.1 or the
button to decrement by 0.1.
Momentary Digital Input Value
The
ON
OFF
button on the GENII CSAH REM Module provides a digital input
value to the GENESIS Controller during normal operation.
This operates as a standard momentary switch, i.e. Press the
ON
OFF
button produces a momentary digital input to the GENESIS controller.
Digital Output Led
The GENII CSAH REM displays a digital state via the system LED during
normal operation.
