Innolas Laser nanio Series, Руководство пользователя и инструкция по установке

Страница: 41 / 48

8. Transport and re-commissioning
8.1. Transport
• Fit the protection plate over the beam output window.
• Drain the cooling system
• Store and transport in a clean, dry environment away from dust, moisture, etc.
• Do not subject the system to excessive shock or vibration. (See 2.6.6)
• Transport in a horizontal position. Maximum tilt angle 15°.
8.2. Recommissioning
Follow the procedures and checks used for the initial installation.
Important!
The complete system must be checked by a qualified specialist before restarting.
DANGER
Risk of electrocution
Switch off and disconnect the equipment from the mains electrical supply before
exposing electrical terminals. Only trained and authorised personnel should
remove covers from the power supply or water to air chiller.
DANGER
Risk of electrocution
Electrical connections must only be made by trained and authorised personnel.
DANGER
Risk of electrocution and damage to equipment
If the insulation around the AC mains supply terminals is damaged do not
connect the power supply. Replace it with an undamaged power supply.
DANGER
Risk of electrocution
Before switching on the AC power, verify the quality of the ground connection
according to the appropriate standards.
nanio Industrial DPSS Laser User and Installation Manual
33 8. Transport and re-commissioning