INNO Instrument View 8+, Руководство пользователя, Страница: 41 / 45

User’s Manual
INNO Instrument, Inc.
40 PAGE
Error Message Cause Solution
Fiber Clad Over
Limit
The fiber is not
located in the
Camera’s field of
view.
Adjust the fiber position and do “motor
calibration” for maintenance.
Focus Motor Home
position Erro
The fusion splicer is
hit by force during
splicing operation. Carry out “motor calibration” for
maintenance. If the problem still
can’t be solved, contact with agency.
Fiber End face Gap
Wrong
Too much [Overlap]
setting
Adjust or initialize [Overlap] setting.
The motor is not
calibrated
Do [Motor Calibration] maintenance.
Motor Distance
Over Limit
The fiber is not
set correctly at
the bottom of the
V-groove. Press the “RESET” button , re-
position the fiber again to seat
it correctly at the bottom of the
V-groove.
There’s dust or dirt
on the fiber surface
Prepare the fiber (stripping,
Cleaning and cleaving) again.
There’s dust or dirt
on the fiber surface Execute the [Dust Check] after
cleaning the lenses and mirrors.
Fiber Mismatch
The fibers on the
two sides are not the
same
It may result in large splice loss if you
continue to splice, Please use the
proper splice mode corresponding to
the fibers.
Cleave Angle Over
Limit
Bad fiber end-face
Prepare the fiber (stripping, cleaning,
and cleaving) again.，Check the
condition of the fiber cleaver. If the
blade is worn, rotate the blade to a
new position.
[Cleave Limit] is set
too low. Increase the “Cleave Limit” to an
adequate limit. (standard value: 3.0°）
Core Angle Over
Limit
[Offset Limit] is set
too low.
Increase the “Core Angle Limit” to
an adequate limit.
(standard value: 1.0°）.
Dust or dirt is on
the V-groove or the
clamp chip.
Clean the V-groove or the clamp chip,
prepare and reposition the fiber again.
Fiber Axis Align
Failed
Axial offset （>0.4um）
Prepare the fiber (stripping,
cleaning, and cleaving) again.
The motor is not
calibrated Do the “Motor Calibration”
maintenance.