Page 11 of 13
Installing the Magnetic Latches
Install the magnetic latches so that they push on the cover switches (see picture).
Note that during the normal operation the
printer will attempt to read cartridges when
you push on the switches. The printer will
see it as closing of the cartridge door.
If the display on the printer says CLOSE L
INKCOVER or CLOSE R INKCOVER, it means
that one of the sensors is not pushed.
Because the location of the switches may
differ from printer to printer, we may put a
piece of soft tubing on the part of the
magnetic latch that pushes on the switch. If
it’s too long, you can always trim it to a
required length.
When both of the magnetic latches are mounted, the printer will immediately read and
recognize the cartridges.
If the printer does not recognize one of the ink Chips, try to pull out the magnetic latch
on the respective side of it and re-inserting it. If printer continues saying CHECK Xx INK,
it could be a problem with the ink Chip.
Setting Up the Electronic Control Devices
Turn the printer power on. Immediately
observe if the LCD displays of the Control
Devices: are they showing anything? If
not, please turn the power of your Seiko
off and double-check the connections of
the electronic control device to the
printer. Use the Select and Enter buttons
to scroll through the menus of the
system. First thing to set up, is the side
on which the control device is installed:
Right side with Cyan, Magenta and Yellow
inks, or the left side, with Light Cyan,
Light Magenta and Black.
Press Select button several times until
you see SETUP. Press Enter and scroll to
SIDE: LEFT or SIDE: RIGHT. Choose the
correct side and press Enter. You can
always get to the top-level menu by
selecting MAIN MENU.
Содержание Pro-CP2
Страница 4: ...Page 4 of 13...
