Page 2 of 3
Step 1.Assemble the chair on a flat, soft surface such as carpet or cloth to prevent scratching the finish. Open the carton and
take out backrest, chair seat and inner box. Then open and take out the two arms and hardware from the inner box.
Step 2.Screw the studs(H1) into the hole in the backrest(P1), and make sure that all the studs(H1) were fully tightened. Then
insert the studs(H1) in the backrest(P1) into the holes in the chair seat(P2) as shown.
Step 3. Open the black fabric on bottom. Insert the flat washer(H6), lock washers(H4) and nuts(H3) to the end of stud(H1) to
assembly the backrest(P1) to chair seat(P2). All the nuts(H3) by spanner(H8).(NOTE: Don't fully tighten the nuts.)
Step 4.Screw the studs(H1) into the hole in right armrest(P4),make sure all the studs(H1) were fully tightened. Then insert the
studs(H1) in right armrest(P4) into the hole of the seat backrest(P1&P2) as shown.
X8
X6
X1
X2
X2
X6
X1
X2
X6
X1
X1
H6
H3
H4
P1
P2
H1
H1
P1
H1
H1
P4
P4
P2
P2
P1
P1
H1
H1
H1
H1
