Part number SP1202
06-07 Subaru WRX 2.5L
04-07 Subaru STi 2.5L
1- 2 pc. Injen cold air intake (CA)
1- 2.75” Injen filter (#1013)
1- 3” straight hose (#3044)
1- 2 3/4” straight hose (#3043)
2- Power-bands (.362) .048 (#4004)
2- Power-bands (.312) .040 (#4003)
1- M6 vibra-mount (#6020)
1- M6 flange nut (#6002)
1- fender washer (#6010)
1- 12” vinyl trim flex-grip (#6023)
1- 3 page instruction
Note:
Do to the sensitivity of the ECU, some
additional engine tuning maybe
required to correct short term fuel
and timing trims
.
Congratulations! You have just purchased the best engineered,
dyno-proven cold air intake system available.
Please check the contents of this box immediately.
Report any defective or missing parts to the Authorized Injen
Technology dealer you purchased this product from.
Before installing any parts of this system, please read the instructions
thoroughly. If you have any questions regarding installation please
contact the dealer you purchased this product from.
Installation DOES require some mechanical skills. A qualified
mechanic is always recommended.
*Do not attempt to install the intake system while the engine is hot.
The installation may require removal of radiator fluid line that may
be hot.
Injen Technology offers a limited lifetime warranty to the original
purchaser against defects in materials and workmanship. Warranty
claims must be handled through the dealer from which the item was
purchased.
Injen Technology 244 Pioneer Place Pomona, CA 91768 USA
Please check the contents of this box immediately.
Note: This intake system was Dyno-tested with an Injen filter and
Injen parts. The use of any other filter or part will void the
warranty and CARB exemption number.
Parts and accessories are available on line at “Injenonline.com”
Note:
The installation of this air intake does require mechanical skills. Removal of the front bumper requires
loosening and removing several plastic plugs and screws that may be difficult. In addition to removing the
bumper, you may also have to remove the air resonator box, battery and tray when beginning this installation.
Injen strongly recommends that this system be installed by a professional mechanic.
MR
Technology, “The World’s First Tuned Intake System!”
Optimum performance, Factory safe air/fuel ratio.
Patent Pending
“An air intake evolution”
Available in wrinkled Red
Process Developed and invented by Injen Technology.
Tri-step process with tuned adapter, calibrates the intake
for a desirable A/F ratio and ultimate power gains.
TPR magazine rates Injen #1 against 8 other manufacturers
