Loosen the 2 remaining nuts holding in the bottom of
the bracket to the frame of vehicle. Pull harness away
from bracket.
Once removed, you should have completly removed
the power steering reservoir bracket and clamp from
vehicle.
Remove the reservoir clamp from vehicle.
With T30 torx bit, loosen the screw holding in intake
tube @ turbo housing.
Loosen the 2 nuts holding in the power steering
reservoir. Also, loosen the 10mm screw holding in
the bracket.
With 10mm socket and ratchet, loosen the bolt holding
in the intake tube on engine and remove.
Carefully pull back the crank case fitting from the
engine using a small flat head screwdriver.
Disconnect the crank case line harness.
Carefully lift intake tube and slide back towards fire-
wall and remove.
Make sure you remove the rubber
gasket on turbo housing.
Carefully pull the clamp apart, and silde making the 2
lines pass the clamp.
Carefully lift and remove the bracket from the vehicle.
Figure 15
Figure 16
Figure 17
Figure 18
Figure 19
Figure 20
Figure 21
Figure 22
Figure 23
Figure 24
Figure 25
Figure 26
Page 3 of Part# SP1126
With 10mm ratchet and extension, loosen the screw
holding in the reservoir clamp.
135i
