6
Wire color chart
Black- Ground
Red- Ignition
Yellow- Co 12 volts
Blue-Positive door dome light trigger
White- Negative door dome light trigger
Audio and Video Input connections
1. Connect the monitor’s power supply cords correctly, according to the
connections diagram above.
2. Connect external signal sources to this monitor through AV1 IN and/or
AV2 IN cables.
1) Connect the audio cables to the AUDIO OUT L (left-white) and R
(right-red) jacks of your external source equipment, and to the
corresponding audio input jacks of the monitor’s AV1 IN or AV2 IN
terminals.
2) Connect the video cable (yellow) to the VIDEO OUT jack of your
external source equipment, and to the video input jack of the monitor’s
AV1 IN or AV2 IN terminals.
3) All connections from any one source should go to the corresponding
source in connections. Use AV1 as the main default mode if only one
source is to be used.
3. Turn on the monitor by pressing the SOURCE button on the main unit or
on the remote control, and turn external equipment on. Press the
SOURCE button to select AV inputs between AV1 IN and AV2 IN. The
default mode will normally be AV1.
NOTE: If there is no signal input to the monitor within 10 seconds, it will turn
off automatically
